Iron Worker

JOB TITLE: IRON WORKER

LOCATION: Midland

PAY: $13.00 - $18.00 Experience Based Pay. May pay more.

THC ALLOWED: NO

Physical, Extensive Background check done, 7-Hr Unpaid Safety training course required for hire.

HOURS: 1 st shift

____________________________________________________________

Ironworker: Performs a combination of duties to dismantle, raise, place, repair and unite girders, columns and other structural-steel members to form completed structures or structure frameworks. Lays out reference points and dimensions on structural shapes for fabricating, welding, and assembling into structural metal products. Fits and assembles structural frameworks using hand tools and welding equipment and following blueprint specifications.

Employee will be more than six feet from ground level, but will be required to use fall protection. Will be exposed to dusty/dirty conditions, but will be required to wear safety glasses with side-shields or mono-goggles. Will also be provided gloves and flame resistant clothing.

· The applicant should have a good selection of tools

· a valid driver’s license

· Ability to pass a drug screen

· Ability to complete paperwork and timecards on a daily basis.

Job responsibilities include but are not limited to;

• Sets up hoisting equipment for raising and placing structural steel members.
• Fastens steel members to cable of hoist, using chain, cable or rope
• Signals worker operating hoisting equipment to lift and place steel member
• Guides member using tag line (rope) in order to guide it into position
• Pulls, pushes, or pries steel members into approximate position while member is supported by hoisting device
• Guides members into final position, using turnbuckles, crowbars, jacks and hand tools
• Aligns bolt holes in member with corresponding holes in previously placed member by driving drift pins or handle of wrench through holes
• Verifies vertical and horizontal alignment of members, using plumb bob and level
• Bolts aligned members to keep them in position until they can be permanently bolted or welded in place
• Uses impact wrenches to tighten structural bolts and nuts
• Cuts and welds steel members to make alterations, using oxyacetylene welding equipment
• May use transit to locate reference points and erects ladders and scaffolding to fit together large assemblies

· maintenance and installation of loading dock equipment including overhead doors

· including troubleshooting and repairing hydraulics, motors, overhead doors, levelers, vehicle restraints, etc.

· Electrical experience in reading voltages, diagnosing electrical components, and tracing wires is a plus as is welding experience.

Technicians safely travel to the customer's location, locate the equipment requiring service, diagnose the problem with the equipment, communicate with the customer both verbally and in writing to explain the needed repairs, get approval on repair work and proceed accordingly with the repairs.

If you have what it takes to fulfill the requirement listed, send us your resume!!!